Single Phase Electronic Starter (GES)

GES Single phase motor, compressor & heater are very widely used in home appliances. They are operated by switch, MCB...

GES

Single phase motor, compressor & heater are very widely used in home appliances. They are operated by switch, MCB or mechanical starters which does not provide sufficient protection to motor and does not isolate the appliances in case of power failure. Electronic single phase motor starters provide protection to motor against over current, high-low voltage and isolates the motor in case of power failure. Starters are available in elegant, dust proof ABS plastic enclosure with white color.

Technical Specification
Operating Voltage 140 to 280 V
Current Range 4-10 A / 8-14 A / 10-16 A / 14-22 A
Over load Tripping As per inverse time current characteristic
Low/High Cut-Off 130 V – 280 V
Low/High Cut-in 140 V – 270 V
On-Off / Reset By manual push button, auto start
Indication Motor On, High-low voltage, Over Load
Dimension 105 x 140 x 70 mm. (Approx.)
Weight 550 gms. (Approx)
Colour White

Salient Features

  • Electronic Start-Stop control.
  • Electronic over load protection with high level accuracy.
  • High-Low voltage cut-off and indicators against sudden and extreme high-low voltage with hysteresis gaps.

  • Auto – Manual start facility. (GES-A)
  • Electronic Dry-run protection. (GES-D)
  • Engineering grade plastic enclosure.

Features Switch MCB Mechanical Starters Glees Starters
Overload Protection Not Provided Limited,trips in short circuits only Provided but not accurate Accurate Overload Protection
Low/High Voltage Cut-off Not Provided Not Provided Not Provided Provided at 130V-280V
On-Off Operation Manual by Switch Manual by MCB Manual by push button Manual by push button
Powe Failure Condition Remains On Remains On Remains On Isolate the motor when power fails
Life & Maintenance Short life & Not repairable Not repairable Not repairable Long life & repairable

Specifications are subject to change without any prior notice due to our continuous development, improvement and adaptation to customers requirement.